ROCKARMOR ELITE STEEL BULLBAR TO SUIT TOYOTA HILUX N80 2015-2020 (Full Bar Replacement)

NOTE: 2015 - 2017: Full Bumper Replacement (No Grille Cut Required) and on the 2018 - 2020: Full Bumper Replacement (Grille Cut Required if fitting a winch)

 Features:

• 63mm cross tubing
• LED fog lights
• LED parked and indicator lights
• Winch compatible
• Airbag compatible
• Underbody skid plate protection
• Twin antenna & driving light mounts

Designed & tested in Australia, Rockarmor’s Elite steel Bull bar provides your vehicle with the ultimate in front end protection. Making sure air flow to the engine is maintained, the Rockarmor bull bar is manufactured with a heavy duty 63mm diameter cross bar which protects the full front of the vehicle against any potential animal strikes that may harm areas like your head lights, front grill and engine components.  Designed to be functional for vehicles that drive both on road & off road, the Elite Bull bar has been engineered to store vital accessories such as a Winch, UHF Antenna, safety flags, driving lights plus allowance of a high lift jack recovery. The Elite bull bar comes complete with L.E.D fog lights, L.E.D indicators, under body stone guards and is finished with a high quality powder coat that will withstand Australia’s harsh weather conditions. 100% ADR Compliant, and Air Bag approved, Rockarmor’s Elite bull bar is put through a strict set of tests that gives you confidence your vehicle will be protected at all times.

INSTALLATION

To comply with NZTA all daytime running lights should be installed separately to your headlights. Also note that the fog lights need to be adjusted to three degrees down.

If your vehicle's suspension is not upgraded to withstand 60-100kgs, we do recommend that you upgrade the suspension, especially in the front of the vehicle to withstand the weight of the Steel Bumper & optional winch (if an electric winch is installed with the bull bar) If your vehicle's suspension is not upgraded, or if you are running factory suspension, your front suspension will sag and the ride will become bumpy which can possibly lead to further damage. 

We recommend when fitting the bull bar to leave a minimum 10-15mm gap between the bullbar and body of the vehicle. This will allow for movement where the chassis & body move independently. 

FITTING VIDEO