Rockarmor Steel Gt Hoop Bull Bar - Ranger Raptor Next Gen 2023-2024 (Full Bar Replacement)

ROCKARMOR GT HOOP STEEL BULL BAR - FORD RANGER RAPTOR (Full Bar Replacement) & Built In Rated Recovery Point

Designed & Tested in Australia, Rockarmor’s design team left no stone unturned, making sure the Next Gen Ford Raptor GT bull bar would cater for the true 4x4 enthusiast.

With a combination of aggressive lines & sleek touches, which is sure to seek attention from fellow car lovers, Rockarmor’s engineers intergrated every essential feature that benefits all Ford Raptor owners for all types of terrains & situations they may encounter

The Rockarmor GT Bumper, has been engineered to be compatible with your vehicle safety features which include the front safety camera & bumper sensors. The GT Bumper is finished in a highly durable black powder coat finish, Optional colour matching is available through your local Rockarmor Distributor. 

 

Features & Specifications: 

• Built in 3.2Tonne Rated Recovery Points
• 52 mm Top cross tube for maximum frontal protection
• Durable 2.8mm High Quality steel construction for maximum protection
• Designed for high approach angles 
• Built in LED FOG lights & LED Indicator, compatible with factory controls
• Extended centre Bash Plate Included 
• ADR Complied Air bag compatible mounting system
• Factory Sensor & Front Camera Compatible 
  
• Side under Protection panels Included
• Twin Slotted Antenna Mounts located on top Cross Tube
• Twin Hi-Lift jack points 
• Front Protection Buffers
• Accommodation for Electric Winch up to 12,000 pound 
• Laser cut Holes to accommodate for driving lights
• Shot blasted, Chemical Washed 
• Finished off in a high quality black powder coat finish 

INSTALLATION

To comply with NZTA all daytime running lights should be installed separately to your headlights. Also note that the fog lights need to be adjusted to three degrees down.

If your vehicle's suspension is not upgraded to withstand 60-100kgs, we do recommend that you upgrade the suspension, especially in the front of the vehicle to withstand the weight of the Steel Bumper & optional winch (if an electric winch is installed with the bull bar) If your vehicle's suspension is not upgraded, or if you are running factory suspension, your front suspension will sag and the ride will become bumpy which can possibly lead to further damage. 

We recommend when fitting the bull bar to leave a minimum 10-15mm gap between the bullbar and body of the vehicle. This will allow for movement where the chassis & body move independently. 

 

FITMENT GUIDE