Fitting Guides
FITTING GUIDES
Download installation instructions for Rockarmor products.
VEHICLE-SPECIFIC GUIDES
Find your vehicle below to download the correct fitting instructions.
Toyota41 products▾
Ford11 products▾
Nissan5 products▾
Mazda7 products▾
Holden1 products▾
VW1 products▾
GENERAL BULLBAR FITTING GUIDE
Universal step-by-step process for all Rockarmor bullbars
Prepare Your Vehicle & Tools
Park on a flat, level surface and disconnect the battery negative terminal. Allow at least 2 hours for the installation.
Remove Factory Bumper
Following your vehicle's manual, carefully remove the factory front bumper, indicators, fog lights and any sensors. Label all wiring connectors and store fasteners in a parts tray.
Install Mounting Brackets
Position the supplied mounting brackets onto the chassis rails. Hand-thread all bolts first — do not fully secure until the bullbar is offered up and aligned correctly.
Lift & Position Bullbar
With a second person, carefully lift the bullbar onto the mounting brackets. Align the bar centrally and ensure even gaps to the bonnet, headlights and guards.
Final Assembly
Once alignment is correct, secure all fasteners progressively, working from the centre outwards in a star pattern. Hand-tightening should be firm and even — final tightening should always be performed by a qualified installer.
Reconnect Wiring & Sensors
Re-route and reconnect indicators, fog lights, parking sensors and any auxiliary wiring. Ensure all connectors click home and are protected with shrink wrap or loom tape where necessary.
Final Checks
Reconnect the battery and verify: indicators function, parking sensors recalibrated, no warning lights on dash, bullbar is square to the vehicle, and have all fasteners re-checked by a qualified installer.
Need Help?
Our team is here to support your install. Get in touch for advice, replacement parts, or fitter recommendations.
CONTACT ROCKARMOR →
